R&S ESR Series User Manual page 838

®
R&S ESR
[SENSe:]SWEep:TIME <Time>
This command defines the sweep time.
The range depends on the frequency span.
If this command is used in "Spectrum" mode, automatic coupling to resolution band-
width and video bandwidth is switched off.
Parameters:
<Time>
Example:
Manual operation:
[SENSe:]SWEep:TIME:AUTO <State>
In realtime mode, this command automatically sets the sweep time to 32 ms.
In analyzer mode, this command controls the automatic coupling of the sweep time to
the frequency span and bandwidth settings. If
matic coupling is switched off.
Parameters:
<State>
Example:
Manual operation:
[SENSe:]SWEep:TYPE <Type>
This command selects the sweep type.
Parameters:
<Type>
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
refer to data sheet
*RST: (automatic)
SWE:TIME 1s
See "Sweep Time" on page 243
See "Sweeptime Manual"
See "Meas Time" on page 460
ON | OFF
*RST: ON
SWE:TIME:AUTO ON
Activates automatic sweep time.
See "Sweeptime Manual"
See "Sweeptime Auto"
See "Default Coupling"
SWE
Selects analog frequency sweeps.
AUTO
Automatically selects the sweep type (FFT or analog frequency
sweep).
FFT
Selects FFT sweeps.
*RST: AUTO
on page 362
[SENSe:]SWEep:TIME
on page 362
on page 363
on page 365
Remote Control
is used, auto-
835