R&S ESR Series User Manual page 772

®
R&S ESR
[SENSe:]ESPectrum:RANGe<range>:LIMit<source>:STATe <State>
This command sets the type of limit check for all ranges.
Suffix:
<range>
Parameters:
<State>
Example:
Manual operation:
[SENSe:]ESPectrum:RANGe<range>:RLEVel <Value>
This command sets the reference level for the specified range.
Note that this parameter can not be set for all ranges if "Fast SEM" mode is activated
(see
Suffix:
<range>
Parameters:
<Value>
Example:
Manual operation:
[SENSe:]ESPectrum:RANGe<range>:SWEep:TIME <SweepTime>
This command sets the sweep time for the specified range.
User Manual 1175.7068.02 ─ 12
.
irrelevant
ABSolute | RELative | AND | OR
ABSolute
Checks only the absolute limits defined.
RELative
Checks only the relative limits. Relative limits are defined as rel-
ative to the measured power in the reference range.
AND
Combines the absolute and relative limit. The limit check fails
when both limits are violated.
OR
Combines the absolute and relative limit. The limit check fails
when one of the limits is violated.
*RST:
ESP:RANG3:LIM:STAT AND
Sets for all ranges the combined absolute/relative limit check.
See "Limit Check 1-4"
[SENSe:]ESPectrum:HighSPeed
.
1...20
range
Refer to the data sheet.
*RST:
ESP:RANG2:RLEV 0
Sets the reference level of range 2 to 0 dBm.
See "Ref. Level"
Remote Commands in Spectrum Analyzer Mode
REL
on page 261
on page 762).
-20 dBm
on page 260
Remote Control
769