R&S ESR Series User Manual page 845

®
R&S ESR
Manual operation:
[SENSe:]SWEep:EGATe:LENGth <TimeInterval>
This command defines a gate length.
Parameters:
<TimeInterval>
Example:
Manual operation:
[SENSe:]SWEep:EGATe:POLarity <Polarity>
This command determines the polarity of the external gate signal. The setting applies
both to the edge of an edge-triggered signal and the level of a level-triggered signal.
Parameters:
<Polarity>
Example:
Manual operation:
[SENSe:]SWEep:EGATe:SOURce <Source>
This command selects the signal source for gated measurements.
If an IF power signal is used, the gate is opened as soon as a signal at > -20 dBm is
detected within the IF path bandwidth (10 MHz).
For details see the
Parameters:
<Source>
Example:
Manual operation:
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
See "Gate Delay" on page 379
125 ns to 30 s
*RST: 400μs
SWE:EGAT:LENG 10ms
See "Gate Length (Gate Mode Edge)"
POSitive | NEGative
*RST: POSitive
SWE:EGAT:POL POS
See "Trg/Gate Polarity"
See "Trigger Polarity"
"Trg/Gate Source" on page 375 softkey.
EXTernal | IFPower | VIDeo | RFPower | PSEN
*RST: IFPower
SWE:EGAT:SOUR IFP
Switches the gate source to IF power.
See "Gated Trigger (On/Off)"
See "Trg/Gate Source"
See "External" on page 375
See "Video" on page 376
See "RF Power" on page 376
See "IF Power/BB Power"
See "Gated Trigger"
on page 380
on page 377
on page 472
on page 320
on page 375
on page 376
on page 378
Remote Control
842