Enable Optic-Info-Update Interval - Dell Z9500 Reference Manual

at a specific privilege level. If no privilege level is specified, the default is privilege
level 15.
Related enable password
Commands
access a privilege level.

enable optic-info-update interval

Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Z9500
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-
info-update interval command.
Parameters
interval
seconds
Defaults Disabled
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.4
8.3.10.0
Usage To enable polling and to configure the polling frequency, use this command.
Information
Control and Monitoring
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do
not need to enter an enable password.
— configures a password for the enable command and to
Enter the keyword interval then the polling interval in
seconds. The range is from 120 to 6000 seconds. The
default is 300 seconds (5 minutes).
Description
Introduced on the Z9500.
Replacement command for the S4820T. Replaces the
enable xfp-power-updates command.
Replacement command for the Z9000. Replaces the
enable xfp-power-updates command
Replacement command for the S4810 only. Replaces the
enable xfp-power-updates command.
101