Match Ip Address - Dell Z9500 Reference Manual

Version
8.3.11.1
8.3.7.0
8.5.1.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related

match ip address

Commands
match ip next-hop
match ip route-source
routers.
match metric
match route-type
match tag
match ip address
To match routes based on IP addresses specified in an access list, configure a filter.
Z9500
Syntax
match ip address prefix-list-name
To delete a match, use the no match ip address prefix-list-name
command.
Parameters
prefix-list-
name
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
296
Description
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match an IP address.
— redistributes routes that match the next-hop IP address.
— redistributes routes that match routes advertised by other
— redistributes routes that match a specific metric.
— redistributes routes that match a route type.
— redistributes routes that match a specific tag.
Enter the name of configured prefix list, up to 140
characters.
Access Control Lists (ACL)