Port-Channel/Lag (802.3Ad) Commands - D-Link DWS-4000 Series Cli Command Reference

Example: The following shows example CLI display output for the command.
(DWS-4026) #show storm-control
802.3x Flow Control Mode....................... Disable
Example: The following shows example CLI display output for the command.
(DWS-4026) #show storm-control 0/1
Bcast Bcast
Intf Mode Level
------ ------- -------- ------- -------- ------- --------
0/1 Disable
Example: The following shows an example of part of the CLI display output for the command.
(DWS-4026) #show storm-control all
Bcast Bcast
Intf Mode Level
------ ------- -------- ------- -------- ------- --------
0/1 Disable
0/2 Disable
0/3 Disable
0/4 Disable
0/5 Disable
P -C
ORT HANNEL
This section describes the commands you use to configure port-channels, which is defined in the 802.3AD specification, and
that are also known as link aggregation groups (LAGs). Link aggregation allows you to combine multiple full-duplex Ethernet
links into a single logical link. Network devices treat the aggregation as if it were a single link, which increases fault tolerance
and provides load sharing. The LAG feature initially load shares traffic based upon the source and destination MAC
address.Assign the port-channel (LAG) VLAN membership after you create a port-channel. If you do not assign VLAN
membership, the port-channel might become a member of the management VLAN which can result in learning and switching
issues.
A port-channel (LAG) interface can be either static or dynamic, but not both. All members of a port channel must participate
in the same protocols.) A static port-channel interface does not require a partner system to be able to aggregate its member
ports.
Note: If you configure the maximum number of dynamic port-channels (LAGs) that your platform supports,
additional port-channels that you configure are automatically static.
port-channel
This command configures a new port-channel (LAG) and generates a logical slot/port number for the port-channel. The
<name> field is a character string which allows the dash "-" character as well as alphanumeric characters. Use the show
port channel command to display the slot/port number for the logical interface.
Note: Before you include a port in a port-channel, set the port physical mode. For more information, see
on page 16.
Mcast Mcast
Mode Level
5% Disable
Mcast Mcast
Mode Level
5% Disable
5% Disable
5% Disable
5% Disable
5% Disable
/LAG (802.3
AD

Port-Channel/LAG (802.3ad) Commands

Ucast Ucast
Mode Level
5% Disable 5%
Ucast Ucast
Mode Level
5% Disable 5%
5% Disable 5%
5% Disable 5%
5% Disable 5%
5% Disable 5%
) C
OMMANDS
"speed"
79