D-Link DWS-4000 Series Cli Command Reference page 223

Maximum Pre-authentication History Entries..... 500
Total Pre-authentication History Entries....... 0
Maximum Roam History Entries................... 500
Total Roam History Entries..................... 0
show wireless statistics
This show command displays the current global Unified Switch statistics. The counters are aggregated for the peer group
the switch acts as the Cluster Controller for the group. If the switch is not the Cluster Controller, the values are for this switch
only.
Format
show wireless statistics
Mode Privileged EXEC
Field Description
WLAN Bytes Shows the total bytes received across all APs managed by the switch.
Received
WLAN Bytes Shows the total bytes transmitted across all APs managed by the switch.
Transmitted
WLAN Packets Shows the total number of packets received across all APs managed by the switch.
Received
WLAN Packets Shows the total number of packets transmitted across all APs managed by the switch.
Transmitted
WLAN Bytes Shows the total bytes received across all APs managed by the switch and dropped.
Received Dropped
WLAN Bytes Shows the total bytes transmitted across all APs managed by the switch and dropped.
Transmit Dropped
WLAN Packets Shows the total number of packets received across all APs managed by the switch and dropped.
Receive Dropped
WLAN Packets Shows the total number of packets transmitted across all APs managed by the switch and dropped.
Transmit Dropped
Example: The following shows example CLI display output for the command.
(DWS-4026) #show wireless statistics <cr>
WLAN Bytes Received............................ 0
WLAN Bytes Transmitted......................... 0
WLAN Packets Received.......................... 0
WLAN Packets Transmitted....................... 0
WLAN Bytes Receive Dropped..................... 0
WLAN Bytes Transmit Dropped.................... 0
WLAN Packets Receive Dropped................... 0
WLAN Packets Transmit Dropped.................. 0
show wireless switch status
This show command displays the current global Unified Switch status parameters. If the Unified Switch is a Cluster
Controller, then this command shows per-switch status parameters for all the switches in the wireless network. For the switch
that is not acting as a Cluster Controller, only the local status parameters are displayed.
Unified Switch Commands
215