Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
When you specify a value for <vlanid>, the following additional information appears.
Field
Description
VLAN Admin Mode Indicates whether iGMP Snooping Querier is active on the VLAN.
VLAN Operational
Indicates whether IGMP Snooping Querier is in "Querier" or "Non-Querier" state. When the switch is
State
in Querier state, it will send out periodic general queries. When in Non-Querier state, it will wait for
moving to Querier state and does not send out any queries.
VLAN Operational
Indicates the time to wait before removing a Leave from a host upon receiving a Leave request. This
Max Response
value is calculated dynamically from the Queries received from the network. If the Snooping Switch is
Time
in Querier state, then it is equal to the configured value.
Querier Election
Indicates whether the IGMP Snooping Querier participates in querier election if it discovers the
Participation
presence of a querier in the VLAN.
Querier VLAN
The IP address will be used in the IPv4 header while sending out IGMP queries on this VLAN. It can
Address
be configured using the appropriate command.
Operational
The version of IPv4 will be used while sending out IGMP queries on this VLAN.
Version
Last Querier
Indicates the IP address of the most recent Querier from which a Query was received.
Address
Last Querier
Indicates the IGMP version of the most recent Querier from which a Query was received on this VLAN.
Version
When the optional argument detail is used, the command shows the global information and the information for all Querier-
enabled VLANs.
© 2009 D-Link Corporation. All Rights Reserved
128
Advertisement
Table of Contents
