D-Link DWS-4000 Series Cli Command Reference page 435

no logging cli-command
This command disables the CLI command Logging feature.
Format
no logging cli-command
Mode Global Config
logging console
This command enables logging to the console. You can specify the <severitylevel> value as either an integer from 0 to
7 or symbolically through one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning
(4), notice (5), info (6), or debug (7).
Default disabled; critical when enabled
Format
logging console [severitylevel]
Mode Global Config
no logging console
This command disables logging to the console.
Format
no logging console
Mode Global Config
logging host
This command enables logging to a host. You can configure up to eight hosts. The <ipaddr|hostname> is the IP address
of the logging host. The <addresstype> indicates the type of address (ipv4 or dns) being passed. The <port> value is a
port number from 1 to 65535. You can specify the <severitylevel> value as either an integer from 0 to 7 or symbolically
through one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning (4), notice (5),
info (6), or debug (7).
Default • port—514
• level—critical (2)
Format
logging host <ipaddr|hostname> <addresstype> [<port>][<severitylevel>]
Mode Global Config
logging host remove
This command disables logging to host. See
Format
logging host remove <hostindex>
Mode Global Config
"show logging hosts" on page 429
Logging Commands
for a list of host indexes.
427