D-Link DWS-4000 Series Cli Command Reference page 212

D-Link Unified Switch CLI Command Reference
no ap authentication
The no version of this command disables AP authentication. APs are not required to authenticate to the Unified Switch upon
discovery.
Format
no ap authentication
Mode Wireless Config
ap client-qos
This command enables AP client QoS operation globally for the Unified Switch. When enabled, and when the network client
QoS mode is also enabled, clients associated to that network may have one or more of the following QoS characteristics in
effect in the down and/or up directions: access control, bandwidth limiting, and differentiated services.
Note: This command takes effect in an AP without requiring that the AP profile be re-applied.
Default Disable
Format
ap client-qos
Mode Wireless Config
no ap client-qos
The no version of this command disables AP client QoS operation globally. Client traffic is not subject to QoS processing in
any APs attached to this Unified Switch.
Format
no ap client-qos
Mode Wireless Config
snmp-server enable traps wireless
This command globally enables the Unified Switch SNMP traps. The specific wireless trap groups are configured using the
trapflags command in Wireless Config Mode.
Default Disable
Format
snmp-server enable traps wireless
Mode Global Config
no snmp-server enable traps wireless
The no version of this command globally disables all Unified Switch SNMP traps.
Format
no snmp-server enable traps wireless
Mode Global Config
© 2009 D-Link Corporation. All Rights Reserved
204