D-Link DWS-4000 Series Cli Command Reference page 509

snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to receive traps). Disabled
trap receivers are inactive (not able to receive traps).
Format
snmptrap mode <name> <ipaddr>
Mode Global Config
no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are unable to receive traps.
Format
no snmptrap mode <name> <ipaddr>
Mode Global Config
snmp trap link-status
This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See "snmp-server enable traps
linkmode" on page 499.
Format
snmp trap link-status
Mode Interface Config
no snmp trap link-status
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled.
Format
no snmp trap link-status
Mode Interface Config
snmp trap link-status all
This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled. See "snmp-server enable traps
linkmode" on page 499.
Format
snmp trap link-status all
Mode Global Config
SNMP Commands
501