Ieee 802.1X Supplicant Authentication; Table 10: Ieee 802.1X Supplicant Commands - D-Link DWL-6600AP Cli Command Reference

D-Link UAP CLI Command Reference
Action
Set the AP to Managed mode.
Set the pass phrase for AP-to-switch
authentication.
Configure the IP address of up to
four D-Link Unified Switches on
your network.

IEEE 802.1X Supplicant Authentication

Use the 802.1X Supplicant Authentication settings to configure the access point to authenticate to a secured
wired network.
Action
Enable and disable the 802.1X
supplicant.
Set the 802.1X user name.
Set the 802.1X password.
D-Link
November 7, 2011
Table 9: Managed Access Point Commands (Cont.)
Command
set managed-ap mode {up | down}
set managed-ap pass-phrase password
Note: The password you enter must match the local authentication
password you configure for Valid APs on the D-Link Unified Switch.
To remove the password, enter the command without the password
variable.
set managed-ap switch-address-1 ip_address
set managed-ap switch-address-2 ip_address
set managed-ap switch-address-3 ip_address
set managed-ap switch-address-4 ip_address
Example:
set managed-ap switch-address-1 192.168.2.123

Table 10: IEEE 802.1X Supplicant Commands

Command
set dot1x-supplicant status {up | down}
set dot1x-supplicant user name
set dot1x-supplicant password password
IEEE 802.1X Supplicant Authentication
Unified Wired and Wireless Access System
Page 28