D-Link DWS-4000 Series Cli Command Reference page 45

no vlan port tagging all
This command configures the tagging behavior for all interfaces in a VLAN to disabled. If tagging is disabled, traffic is
transmitted as untagged frames. The ID is a valid VLAN identification number.
Format
no vlan port tagging all
Mode Global Config
vlan protocol group
This command adds protocol-based VLAN groups to the system. The <groupName> is a character string of 1 to 16
characters. When it is created, the protocol group will be assigned a unique number that will be used to identify the group
in subsequent commands.
Format
vlan protocol group <groupname>
Mode Global Config
vlan protocol group add protocol
This command adds the <protocol> to the protocol-based VLAN identified by <groupid>. A group may have more than
one protocol associated with it. Each interface and protocol combination can only be associated with one group. If adding a
protocol to a group causes any conflicts with interfaces currently associated with the group, this command fails and the
protocol is not added to the group. The possible values for protocol are ip, arp, and ipx.
Default none
Format
vlan protocol group add protocol <groupid> <protocol>
Mode Global Config
no vlan protocol group add protocol
This command removes the <protocol> from this protocol-based VLAN group that is identified by this <groupid>. The
possible values for protocol are ip, arp, and ipx.
Format
no vlan protocol group add protocol <groupid> <protocol>
Mode Global Config
vlan protocol group remove
This command removes the protocol-based VLAN group that is identified by this <groupid>.
Format
vlan protocol group remove <groupid>
Mode Global Config
protocol group
This command attaches a <vlanid> to the protocol-based VLAN identified by <groupid>.
associated with one VLAN at a time, however the VLAN association can be changed.
VLAN Commands
A group may only be
37