Table of Contents
Advertisement
particular interface before deleting the interface from the entry. This value must be greater than the IGMPv3 Maximum
Response time value. The range is 2 to 3600 seconds.
Default
260 seconds
Format
set igmp groupmembership-interval <2-3600>
Mode
• Interface Config
• Global Config
Format
set igmp groupmembership-interval <vlan_id> <2-3600>
Mode
VLAN Config
no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
Format
no set igmp groupmembership-interval
Mode
• Interface Config
• Global Config
Format
no set igmp groupmembership-interval <vlan_id>
Mode
VLAN Config
set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, or on a particular interface or VLAN. The Maximum
Response time is the amount of time in seconds that a switch will wait after sending a query on an interface because it did
not receive a report for a particular group in that interface. This value must be less than the IGMP Query Interval time value.
The range is 1 to 25 seconds.
Default
10 seconds
Format
set igmp maxresponse <1-25>
Mode
• Global Config
• Interface Config
Format
set igmp maxresponse <vlan_id> <1-25>
Mode
VLAN Config
no set igmp maxresponse
This command sets the max response time (on the interface or VLAN) to the default value.
Format
no set igmp maxresponse
Mode
• Global Config
• Interface Config
IGMP Snooping Configuration Commands
121
Advertisement
Table of Contents
