Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
Primary IP Address............................. 1.2.3.4/255.255.255.0
Secondary IP Address(es)....................... 21.2.3.4/255.255.255.0
............................................... 22.2.3.4/255.255.255.0
Helper IP Address.............................. 1.2.3.4
............................................... 1.2.3.5
Routing Mode................................... Disable
Administrative Mode............................ Enable
Forward Net Directed Broadcasts................ Disable
Proxy ARP...................................... Enable
Local Proxy ARP................................ Disable
Active State................................... Inactive
Link Speed Data Rate........................... Inactive
MAC Address.................................... 00:10:18:82:0C:68
Encapsulation Type............................. Ethernet
IP MTU......................................... 1500
Bandwidth...................................... 100000 kbps
Destination Unreachables....................... Enabled
ICMP Redirects................................. Enabled
show ip interface brief
This command displays summary information about IP configuration settings for all ports in the router.
Format
show ip interface brief
Modes
• Privileged EXEC
• User EXEC
Term
Definition
Interface
Valid slot and port number separated by a forward slash.
State
Routing operational state of the interface.
IP Address
The IP address of the routing interface in 32-bit dotted decimal format.
IP Mask
The IP mask of the routing interface in 32-bit dotted decimal format.
Netdir Bcast
Indicates if IP forwards net-directed broadcasts on this interface. Possible values are Enable or
Disable.
MultiCast Fwd
The multicast forwarding administrative mode on the interface. Possible values are Enable or Disable.
show ip route
This command displays the routing table. The <ip-address> specifies the network for which the route is to be displayed
and displays the best matching best-route for the address. The <mask> specifies the subnet mask for the given <ip-
address>. When you use the longer-prefixes keyword, the <ip-address> and <mask> pair becomes the prefix, and
the command displays the routes to the addresses that match that prefix. Use the <protocol> parameter to specify the
protocol that installed the routes. The value for <protocol> can be connected, rip, or static. Use the all parameter
to display all routes including best and non-best routes. If you do not use the all parameter, the command only displays the
best route.
Note: If you use the connected keyword for <protocol>, the all option is not available because there are no
best or non-best connected routes.
© 2009 D-Link Corporation. All Rights Reserved
174
Advertisement
Table of Contents
