D-Link DWS-4000 Series Cli Command Reference page 52

D-Link Unified Switch CLI Command Reference
no mode dvlan-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By default, Double VLAN Tunneling is
disabled.
Format
no mode dvlan-tunnel
Mode Interface Config
show dot1q-tunnel
Use this command without the optional parameters to display all interfaces enabled for Double VLAN Tunneling. Use the
optional parameters to display detailed information about Double VLAN Tunneling for the specified interface or all interfaces.
Format
show dot1q-tunnel [interface {<slot/port> | all}]
Mode • Privileged EXEC
• User EXEC
Term Definition
Interface Valid slot and port number separated by a forward slash.
Mode The administrative mode through which Double VLAN Tunneling can be enabled or disabled. The
default value for this field is disabled.
EtherType A 2-byte hex EtherType to be used as the first 16 bits of the DVLAN tunnel. There are three different
EtherType tags. The first is 802.1Q, which represents the commonly used value of 0x8100. The
second is vMAN, which represents the commonly used value of 0x88A8. If EtherType is not one of
these two values, then it is a custom tunnel value, representing any value in the range of 0 to 65535.
show dvlan-tunnel
Use this command without the optional parameters to display all interfaces enabled for Double VLAN Tunneling. Use the
optional parameters to display detailed information about Double VLAN Tunneling for the specified interface or all interfaces.
Format
show dvlan-tunnel [interface {<slot/port> | all}]
Mode • Privileged EXEC
• User EXEC
Term Definition
Interface Valid slot and port number separated by a forward slash.
Mode The administrative mode through which Double VLAN Tunneling can be enabled or disabled. The
default value for this field is disabled.
EtherType A 2-byte hex EtherType to be used as the first 16 bits of the DVLAN tunnel. There are three different
EtherType tags. The first is 802.1Q, which represents the commonly used value of 0x8100. The
second is vMAN, which represents the commonly used value of 0x88A8. If EtherType is not one of
these two values, then it is a custom tunnel value, representing any value in the range of 0 to 65535.
© 2009 D-Link Corporation. All Rights Reserved
44