D-Link Unified Switch CLI Command Reference
A
-V
UTO
OICE OVER
This section describes the commands you use to configure Auto-Voice over IP (VoIP) commands. The Auto-VoIP feature
explicitly matches VoIP streams in Ethernet switches and provides them with a better class-of-service than ordinary traffic.
When you enable the Auto-VoIP feature on an interface, the interface scans incoming traffic for the following call-control
protocols:
•
Session Initiation Protocol (SIP)
•
H.323
•
Skinny Client Control Protocol (SCCP)
When a call-control protocol is detected, the switch assigns the traffic in that session to the highest CoS queue, which is
generally used for time-sensitive traffic.
auto-voip all
Use this command to enable VoIP Profile on the interfaces of the switch.
Default
disabled
Format
auto-voip all
Mode
Global Config
no auto-voip all
Use this command to disable VoIP Profile on the interfaces of the switch.
Format
no auto-voip all
Mode
Global Config
auto-voip
Use this command to enable VoIP Profile on the interface.
Default
disabled
Format
auto-voip
Mode
Interface Config
no auto-voip
Use this command to disable VoIP Profile on the interface.
Format
no auto-voip all
Mode
Interface Config
show auto-voip
Use this command to display the VoIP Profile settings on the interface or interfaces of the switch.
© 2009 D-Link Corporation. All Rights Reserved
406
IP C
OMMANDS