D-Link DWS-4000 Series Cli Command Reference page 439

Parameter Description
count Use the optional count parameter to specify the number of probes to send for each TTL value. Range
is 1 to 10 probes.
port Use the optional port parameter to specify destination UDP port of the probe. This should be an
unused port on the remote destination system. Range is 1 to 65535.
size Use the optional size parameter to specify the size, in bytes, of the payload of the Echo Requests
sent. Range is 0 to 65507 bytes.
The following are examples of the CLI command.
Example: traceroute Success:
(DWS-4026) # traceroute 10.240.10.115 initTtl 1 maxTtl 4 maxFail 0 interval 1 count 3
port 33434 size 43
Traceroute to 10.240.10.115 ,4 hops max 43 byte packets:
1 10.240.4.1 708 msec
2 10.240.10.115
Hop Count = 1 Last TTL = 2 Test attempt = 6 Test Success = 6
Example: traceroute Failure:
(DWS-4026) # traceroute 10.40.1.1 initTtl 1 maxFail 0 interval 1 count 3
port 33434 size 43
Traceroute to 10.40.1.1 ,30 hops max 43 byte packets:
1 10.240.4.1 19 msec
2 10.240.1.252
3 172.31.0.9 277 msec
4 10.254.1.1 289 msec
5 10.254.21.2 287 msec
6 192.168.76.2
7 0.0.0.0 0 msec *
Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18
clear config
This command resets the configuration to the factory defaults without powering off the switch. When you issue this
command, a prompt appears to confirm that the reset should proceed. When you enter y, you automatically reset the current
configuration on the switch to the default values. It does not reset the switch.
Format
clear config
Mode Privileged EXEC
clear counters
This command clears the statistics for a specified <slot/port>, for all the ports, or for the entire switch based upon the
argument.
Format
clear counters {<slot/port> | all}
Mode Privileged EXEC
41 msec
0 msec 0 msec
18 msec
0 msec 0 msec
276 msec
327 msec
293 msec
290 msec 291 msec
11 msec
0 msec
9 msec
1 msec
277 msec
282 msec
296 msec
289 msec
System Utility and Clear Commands
431