D-Link DWS-4000 Series Cli Command Reference page 355

Default 120
Format
statistics interval <interval>
Mode Captive Portal Config
no statistics interval
Use this command to set the reporting interval to the default.
Format
no statistics interval
Mode Captive Portal Config
snmp-server enable traps captive-portal
This command globally enables the captive portal traps. The specific captive portal traps are configured using the
trapflags command in Captive Portal Config Mode.
Default Disable
Format
snmp-server enable traps captive-portal
Mode Global Config
no snmp-server enable traps captive-portal
This command globally disables all the captive portal traps.
Format
no snmp-server enable traps captive-portal
Mode Global Config
trapflags (Captive Portal Config Mode)
This command enables captive portal SNMP traps. If no parameters are specified, then all traps are enabled. SNMP traps
can also be enabled individually by supplying the optional parameters.
The client-auth-failure option allows the SNMP agent to send a trap when a client attempts to authenticate with a
captive portal but is unsuccessful.
The client-connect option allows the SNMP agent to send a trap when a client authenticates with and connects to a
captive portal.
The client-db-full option allows the SNMP agent to send a trap each time an entry cannot be added to the client
database because it is full.
The client-disconnect option allows the SNMP agent to send a trap when a client disconnects from a captive portal.
Default Disabled
Format
trapflags [{client-auth-failure | client-connect |
client-db-full | client-disconnect}]
Mode Captive Portal Config
Captive Portal Global Commands
347