D-Link DWS-4000 Series Cli Command Reference page 180

D-Link Unified Switch CLI Command Reference
no ip mtu
This command resets the ip mtu to the default value.
Format
no ip mtu <mtu>
Mode Interface Config
encapsulation
This command configures the link layer encapsulation type for the packet. The encapsulation type can be ethernet or
snap.
Default ethernet
Format
encapsulation {ethernet | snap}
Mode Interface Config
Note: Routed frames are always ethernet encapsulated when a frame is routed to a VLAN.
show ip brief
This command displays all the summary information of the IP, including the ICMP rate limit configuration and the global ICMP
Redirect configuration.
Format
show ip brief
Modes • Privileged EXEC
• User EXEC
Term
Default Time to Live
Routing Mode
Maximum Next Hops
Maximum Routes
ICMP Rate Limit Interval Shows how often the token bucket is initialized with burst-size tokens. Burst-interval is from 0 to
ICMP Rate Limit Burst
Size
ICMP Echo Replies
ICMP Redirects
Example: The following shows example CLI display output for the command.
(DWS-4026) #show ip brief
Default Time to Live........................... 64
Routing Mode................................... Disabled
Maximum Next Hops.............................. 4
© 2009 D-Link Corporation. All Rights Reserved
172
Definition
The computed TTL (Time to Live) of forwarding a packet from the local router to the final
destination.
Shows whether the routing mode is enabled or disabled.
The maximum number of next hops the packet can travel.
The maximum number of routes the packet can travel.
2147483647 milliseconds. The default burst-interval is 1000 msec.
Shows the number of ICMPv4 error messages that can be sent during one burst-interval . The
range is from 1 to 200 messages. The default value is 100 messages.
Shows whether ICMP Echo Replies are enabled or disabled.
Shows whether ICMP Redirects are enabled or disabled.