Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
no users snmpv3 accessmode
This command sets the snmpv3 access privileges for the specified user as readwrite for the "admin" user and readonly for
all other users. The <username> value is the user name for which the specified access mode will apply.
Format
no users snmpv3 accessmode <username>
Mode
Global Config
users snmpv3 authentication
This command specifies the authentication protocol to be used for the specified user. The valid authentication protocols are
none, md5 or sha. If you specify md5 or sha, the login password is also used as the snmpv3 authentication password and
therefore must be at least eight characters in length. The <username> is the user name associated with the authentication
protocol. You must enter the <username> in the same case you used when you added the user. To see the case of the
<username>, enter the show users command.
Default
no authentication
Format
users snmpv3 authentication <username> {none | md5 | sha}
Mode
Global Config
no users snmpv3 authentication
This command sets the authentication protocol to be used for the specified user to none. The <username> is the user name
for which the specified authentication protocol is used.
Format
no users snmpv3 authentication <username>
Mode
Global Config
users snmpv3 encryption
This command specifies the encryption protocol used for the specified user. The valid encryption protocols are des or none.
If you select des, you can specify the required key on the command line. The encryption key must be 8 to 64 characters
long. If you select the des protocol but do not provide a key, the user is prompted for the key. When you use the des protocol,
the login password is also used as the snmpv3 encryption password, so it must be a minimum of eight characters. If you
select none, you do not need to provide a key.
The <username> value is the login user name associated with the specified encryption. You must enter the <username>
in the same case you used when you added the user. To see the case of the <username>, enter the show users
command.
Default
no encryption
Format
users snmpv3 encryption <username> {none | des[key]}
Mode
Global Config
© 2009 D-Link Corporation. All Rights Reserved
492
Advertisement
Table of Contents
