Mac Database Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
Note: Some of the information below displays only if you are using the BCM56224, BCM56514, BCM56624, and
BCM56820platforms.
Term Definition
First Fragment May be enabled or disabled. The factory default is disabled.
Mode
Min TCP Hdr Size The factory default is 20.
<0-255>
ICMP Mode May be enabled or disabled. The factory default is disabled.
Max ICMPv4 Pkt The range is 0-1023. The factory default is 512.
Size
Max ICMPv6 Pkt The range is 0-16384. The factory default is 512.
Size
ICMP Fragment May be enabled or disabled. The factory default is disabled.
Mode
L4 Port Mode May be enabled or disabled. The factory default is disabled.
TCP Port Mode May be enabled or disabled. The factory default is disabled.
UDP Port Mode May be enabled or disabled. The factory default is disabled.
SIPDIP Mode May be enabled or disabled. The factory default is disabled.
SMACDMAC Mode May be enabled or disabled. The factory default is disabled.
TCP Flag Mode May be enabled or disabled. The factory default is disabled.
TCP FIN&URG& May be enabled or disabled. The factory default is disabled.
PSH Mode
TCP Flag & May be enabled or disabled. The factory default is disabled.
Sequence Mode
TCP SYN Mode May be enabled or disabled. The factory default is disabled.
TCP SYN & FIN May be enabled or disabled. The factory default is disabled.
Mode
TCP Fragment May be enabled or disabled. The factory default is disabled.
Mode
TCP Offset Mode May be enabled or disabled. The factory default is disabled.
MAC D
ATABASE
This section describes the commands you use to configure and view information about the MAC databases.
© 2009 D-Link Corporation. All Rights Reserved
154
C
OMMANDS