Table of Contents
Advertisement
enable passwd encrypted
This command allows the administrator to transfer the enable password between devices without having to know the
password. The <password> parameter must be exactly 128 hexadecimal characters.
Format
enable passwd encrypted <password>
Mode
Privileged EXEC
logout
This command closes the current telnet connection or resets the current serial connection.
Note: Save configuration changes before logging out.
Format
logout
Modes
• Privileged EXEC
• User EXEC
ping
Use this command to determine whether another computer is on the network. Ping provides a synchronous response when
initiated from the CLI and Web interfaces.
Default
• The default count is 1.
• The default interval is 3 seconds.
• The default size is 0 bytes.
Format
ping <ipaddress|hostname> [count <count>] [interval <interval>] [size <size>]
Modes
• Privileged EXEC
• User EXEC
Using the options described below, you can specify the number and size of Echo Requests and the interval between Echo
Requests.
Parameter
Description
count
Use the count parameter to specify the number of ping packets (ICMP Echo requests) that are sent
to the destination address specified by the <ip-address> field. The range for <count> is 1 to 15
requests.
interval
Use the interval parameter to specify the time between Echo Requests, in seconds. Range is 1 to
60 seconds.
size
Use the size parameter to specify the size, in bytes, of the payload of the Echo Requests sent. Range
is 0 to 65507 bytes.
The following are examples of the CLI command.
Example: ping success:
(DWS-4026) #ping 10.254.2.160 count 3 interval 1 size 255
Pinging 10.254.2.160 with 255 bytes of data:
System Utility and Clear Commands
433
Advertisement
Table of Contents
