Table of Contents
Advertisement
no set igmp querier version
Use this command to set the IGMP Querier version to its default value.
Format
no set igmp querier version
Mode
Global Config
set igmp querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election process when it discovers the
presence of another Querier in the VLAN. When this mode is enabled, if the Snooping Querier finds that the other Querier's
source address is better (less) than the Snooping Querier's address, it stops sending periodic queries. If the Snooping
Querier wins the election, then it will continue sending periodic queries.
Default
disabled
Format
set igmp querier election participate
Mode
VLAN Config
no set igmp querier election participate
Use this command to set the Snooping Querier not to participate in querier election but go into non-querier mode as soon
as it discovers the presence of another querier in the same VLAN.
Format
no set igmp querier election participate
Mode
VLAN Config
show igmpsnooping querier
Use this command to display IGMP Snooping Querier information. Configured information is displayed whether or not IGMP
Snooping Querier is enabled.
Format
show igmpsnooping querier [{detail | vlan <vlanid>}]
Mode
Privileged EXEC
When the optional argument <vlanid> is not used, the command displays the following information.
Field
Description
Admin Mode
Indicates whether or not IGMP Snooping Querier is active on the switch.
Admin Version
The version of IGMP that will be used while sending out the queries.
Querier Address
The IP Address which will be used in the IPv4 header while sending out IGMP queries. It can be
configured using the appropriate command.
Query Interval
The amount of time in seconds that a Snooping Querier waits before sending out the periodic general
query.
Querier Timeout
The amount of time to wait in the Non-Querier operational state before moving to a Querier state.
IGMP Snooping Querier Commands
127
Advertisement
Table of Contents
