Lldp-Med Commands - D-Link DWS-4000 Series Cli Command Reference

Term Definition
Chassis ID The chassis of the local device.
Port ID Subtype The type of port on the local device.
Port ID The port number that transmitted the LLDPDU.
System Name The system name of the local device.
System Describes the local system by identifying the system name and versions of hardware, operating
Description system, and networking software supported in the device.
Port Description Describes the port in an alpha-numeric format.
System Indicates the primary function(s) of the device.
Capabilities
Supported
System Shows which of the supported system capabilities are enabled.
Capabilities
Enabled
Management The type of address and the specific address the local LLDP agent uses to send and receive
Address information.
LLDP-MED C
OMMANDS
Link Layer Discovery Protocol - Media Endpoint Discovery (LLDP-MED) (ANSI-TIA-1057) provides an extension to the LLDP
standard. Specifically, LLDP-MED provides extensions for network configuration and policy, device location, Power over
Ethernet (PoE) management and inventory management.
lldp med
Use this command to enable MED. By enabling MED, you will be effectively enabling the transmit and receive function of
LLDP.
Default disabled
Format
lldp med
Mode Interface Config
no lldp med
Use this command to disable MED.
Format
no lldp med
Mode Interface Config
lldp med confignotification
Use this command to configure all the ports to send the topology change notification.
Default disabled
Format
lldp med confignotification
Mode Interface Config

LLDP-MED Commands

139