Virtual Router Redundancy Protocol Commands - D-Link DWS-4000 Series Cli Command Reference

V R
IRTUAL OUTER
This section describes the commands you use to view and configure Virtual Router Redundancy Protocol (VRRP) and to
view VRRP status information. VRRP helps provide failover and load balancing when you configure two devices as a VRRP
pair.
ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the router.
Default none
Format
ip vrrp
Mode Global Config
no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of VRRP on the router.
Format
no ip vrrp
Mode Global Config
ip vrrp (Interface Config)
Use this command in Interface Config mode to create a virtual router associated with the interface. The parameter <vrid>
is the virtual router ID, which has an integer value range from 1 to 255.
Format
ip vrrp <vrid>
Mode Interface Config
no ip vrrp
Use this command in Interface Config mode to delete the virtual router associated with the interface. The virtual Router ID,
<vrid>, is an integer value that ranges from 1 to 255.
Format
no ip vrrp <vrid>
Mode Interface Config
ip vrrp mode
This command enables the virtual router configured on the specified interface. Enabling the status field starts a virtual router.
The parameter <vrid> is the virtual router ID which has an integer value ranging from 1 to 255.
Default disabled
Format
ip vrrp <vrid> mode
Mode Interface Config
R P
EDUNDANCY

Virtual Router Redundancy Protocol Commands

C
ROTOCOL OMMANDS
181