Table 38: Mfdb Log Message; Table 39: 802.1Q Log Messages; Table 40: 802.1S Log Messages; Table 41: Port Mac Locking Log Message - D-Link DWS-4000 Series Cli Command Reference

Component Message
MFDB mfdbTreeEntryUpdate: entry does not exist
Component Message
802.1Q dot1qIssueCmd: Unable to send message %d to
dot1qMsgQueue for vlan %d - %d msgs in queue
802.1Q dot1qVlanCreateProcess: Attempt to create a vlan
with an invalid vlan id %d ;
VLAN %d not in range,
dot1qMapIntfIsConfigurable: Error accessing
802.1Q
DOT1Q config data for interface %d in
dot1qMapIntfIsConfigurable.
802.1Q dot1qVlanDeleteProcess: Deleting the default
VLAN
802.1Q dot1qVlanMemberSetModify,
dot1qVlanTaggedMemberSetModify: Dynamic
entry %d can only be modified after it is converted
to static
Component Message
802.1S dot1sIssueCmd: Dot1s Msg Queue is full!!!!Event:
%u, on interface: %u, for instance: %u
802.1S dot1sStateMachineRxBpdu(): Rcvd BPDU
Discarded
802.1S dot1sBpduTransmit(): could not get a buffer
Component Message
Port Mac Locking pmlMapIntfIsConfigurable: Error accessing PML
config data for interface %d in
pmlMapIntfIsConfigurable.
Component Message
Protocol Based pbVlanCnfgrInitPhase2Process: Unable to register
VLANs NIM callback

Table 38: MFDB Log Message

Table 39: 802.1Q Log Messages

Table 40: 802.1S Log Messages

Table 41: Port Mac Locking Log Message

Table 42: Protocol-based VLANs Log Messages

Cause
Trying to update a non existing entry.
Cause
dot1qMsgQueue is full.
This accommodates for reserved vlan ids. i.e. 4094
- x.
A default configuration does not exist for this
interface. Typically a case when a new interface is
created and has no pre-configuration.
Typically encountered during clear Vlan and clear
config.
If this vlan is a learnt via GVRP then we cannot
modify it's member set via management.
Cause
The message Queue is full.
The current conditions, like port is not enabled or
we are currently not finished processing another
BPDU on the same interface, does not allow us to
process this BPDU.
Out of system buffers.
Cause
A default configuration does not exist for this
interface. Typically a case when a new interface is
created and has no pre-configuration.
Cause
Appears when nimRegisterIntfChange fails to
register pbVlan for link state changes.
Switching
531