Router Discovery Protocol Commands - D-Link DWS-4000 Series Cli Command Reference

Format
show ip stats
Modes • Privileged EXEC
• User EXEC
R D
OUTER ISCOVERY
This section describes the commands you use to view and configure Router Discovery Protocol settings on the switch. The
Router Discovery Protocol enables a host to discover the IP address of routers on the subnet.
ip irdp
This command enables Router Discovery on an interface.
Default disabled
Format
ip irdp
Mode Interface Config
no ip irdp
This command disables Router Discovery on an interface.
Format
no ip irdp
Mode Interface Config
ip irdp address
This command configures the address that the interface uses to send the router discovery advertisements. The valid values
for <ipaddr> are 224.0.0.1, which is the all-hosts IP multicast address, and 255.255.255.255, which is the limited broadcast
address.
Default 224.0.0.1
Format
ip irdp address <ipaddr>
Mode Interface Config
no ip irdp address
This command configures the default address used to advertise the router for the interface.
Format
no ip irdp address
Mode Interface Config
P C
ROTOCOL OMMANDS

Router Discovery Protocol Commands

177