Sntp And Clock Commands; Sntp Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
Source
<url>
<url>
<url>
<url>
<url>
{image1 | image2}
image1
image2
SNTP C
AND LOCK
This section describes the commands you use to automatically configure the Simple Network Time Protocol (SNTP)
commands, and the time zone and daylight savings time commands.
SNTP C
OMMANDS
sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power of two where <poll-interval>
can be a value from 6 to 16.
Default 6
Format
sntp broadcast client poll-interval <poll-interval>
Mode Global Config
no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default value.
Format
no sntp broadcast client poll-interval
Mode Global Config
sntp client mode
This command enables Simple Network Time Protocol (SNTP) client mode and may set the mode to either broadcast or
unicast.
Default disabled
Format
sntp client mode [broadcast | unicast]
Mode Global Config
© 2009 D-Link Corporation. All Rights Reserved
436
Table 11: Copy Parameters (Cont.)
Destination
nvram:sslpem-root
nvram:sslpem-server
nvram:startup-config Downloads the startup configuration file to the system.
nvram:system-image
{image1 | image2}
<url>
image2
image1
C
OMMANDS
Description
Downloads an HTTP secure-server certificate. For more
information, see "Hypertext Transfer Protocol Commands" on
page 485.
Downloads an HTTP secure-server certificate.
Downloads a code image to the system.
Download an image from the remote server to either image.
Upload either image to the remote server.
Copy image1 to image2.
Copy image2 to image1.