Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the system.
Format
no bootpdhcprelay cidoptmode
Mode
Global Config
bootpdhcprelay enable
This command enables the forwarding of relay requests for BootP/DHCP Relay on the system.
Default
disabled
Format
bootpdhcprelay enable
Mode
Global Config
no bootpdhcprelay enable
This command disables the forwarding of relay requests for BootP/DHCP Relay on the system.
Format
no bootpdhcprelay enable
Mode
Global Config
bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops for BootP/DHCP Relay on the system. The <hops>
parameter has a range of 1 to 16.
Default
4
Format
bootpdhcprelay maxhopcount <1-16>
Mode
Global Config
no bootpdhcprelay maxhopcount
This command configures the default maximum allowable relay agent hops for BootP/DHCP Relay on the system.
Format
no bootpdhcprelay maxhopcount
Mode
Global Config
bootpdhcprelay minwaittime
This command configures the minimum wait time in seconds for BootP/DHCP Relay on the system. When the BOOTP relay
agent receives a BOOTREQUEST message, it MAY use the seconds-since-client-began-booting field of the request as a
factor in deciding whether to relay the request or not. The parameter has a range of 0 to 100 seconds.
Default
0
Format
bootpdhcprelay minwaittime <0-100>
Mode
Global Config
© 2009 D-Link Corporation. All Rights Reserved
188
Advertisement
Table of Contents
