D-Link DWS-4000 Series Cli Command Reference page 482

D-Link Unified Switch CLI Command Reference
network parms
This command sets the IP address, subnet mask and gateway of the device. The IP address and the gateway must be on
the same subnet.
Format
network parms <ipaddr> <netmask> [<gateway>]
Mode Privileged EXEC
network protocol
This command specifies the network configuration protocol to be used. If you modify this value, change is effective
immediately. If you use the bootp parameter, the switch periodically sends requests to a BootP server until a response is
received. If you use the dhcp parameter, the switch periodically sends requests to a DHCP server until a response is
received. If you use the none parameter, you must configure the network information for the switch manually.
Default none
Format
network protocol {none | bootp | dhcp}
Mode Privileged EXEC
network mac-address
This command sets locally administered MAC addresses. The following rules apply:
• Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally administered (b'0') or locally administered
(b'1').
• Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual address (b'0') or a group
address (b'1').
• The second character, of the twelve character macaddr, must be 2, 6, A or E.
A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').
Format
network mac-address <macaddr>
Mode Privileged EXEC
network mac-type
This command specifies whether the switch uses the burned in MAC address or the locally-administered MAC address.
Default burnedin
Format
network mac-type {local | burnedin}
Mode Privileged EXEC
no network mac-type
This command resets the value of MAC address to its default.
Format
no network mac-type
Mode Privileged EXEC
© 2009 D-Link Corporation. All Rights Reserved
474