Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
client-qos bandwidth-limit
This command configures the default maximum bandwidth rate limit in bits per second used by clients associated with this
network that do not obtain their own value via RADIUS.
Note: The specified value is subject to rounding down to the nearest 64000 in the AP, with a minimum rounded
value of 64000.
Format
client-qos bandwidth-limit {down | up} {1-4294967295}
Mode
Network Config
no client-qos bandwidth-limit
The no version of this command sets the client QoS default maximum bandwidth rate limit parameter to 0 for this network,
disabling rate limiting for clients that associate with this network and use this default value.
Format
no client-qos bandwidth-limit {down | up}
Mode
Network Config
client-qos diffserv-policy
This command configures the default Diffserv policy used by clients associated with this network that do not obtain their own
value via RADIUS. The <policy-name> parameter is a case-sensitive alphanumeric string from 1 to 31 characters and
must specify a Diffserv policy that currently exists in the Unified Switch.
Format
client-qos diffserv-policy {down | up} <policy-name>
Mode
Network Config
no client-qos diffserv-policy
The no version of this command removes the client QoS default Diffserv policy parameter configured for this network.
Format
no client-qos diffserv-policy {down | up}
Mode
Network Config
client-qos enable
This command enables AP client QoS operation for the network. When enabled, and when the wireless global client QoS
mode is also enabled, clients associated to this network may have one or more of the following QoS facilities in effect in the
down and/or up directions: access control, bandwidth limiting, and Differentiated services (via policy).
Note: This command takes effect in an AP without requiring that the AP profile be reapplied.
Default
disable
Format
client-qos enable
Mode
Network Config
© 2009 D-Link Corporation. All Rights Reserved
246
Advertisement
Table of Contents
