Access Point Profile Rf Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
A P
CCESS OINT
The commands in this section provide RF configuration per radio interface within an access point profile.
radio
This command enters the AP profile radio configuration mode. In this mode you can modify the radio configuration
parameters for an AP profile.
Format
radio <1-2>
Mode AP Profile Config
Parameter Description
1-2 The radio interface within the AP profile.
enable (AP Profile Radio Config Mode)
This command configures the administrative mode of the radio interface to the "on" state.
Default on
Format
enable
Mode AP Profile Radio Config
no enable
The no version of this command configures the administrative mode of the radio interface to the "off" state.
Format
no enable
Mode AP Profile Radio Config
mode (AP Profile Radio Config Mode)
This command configures the physical layer technology to use on the radio.
Default Radio 1, bgn
Radio 2, an
Format
mode {a | bg | an | bgn | n-only-a | n-only-g}
Mode AP Profile Radio Config
Parameter Description
a Indicates 802.11a as physical mode. Only applicable for radio 1.
bg Indicates 802.11bg as physical mode. Only applicable for radio 2.
an Indicates 802.11a/n as physical mode. Only applicable for radio 1.
© 2009 D-Link Corporation. All Rights Reserved
266
P RF C
ROFILE OMMANDS