Table of Contents
Advertisement
isdp holdtime
This command configures the hold time for ISDP packets that the switch transmits. The hold time specifies how long a
receiving device should store information sent in the ISDP packet before discarding it. The range is given in seconds.
Default
180 seconds
Format
isdp holdtime <10-255>
Mode
Global Config
isdp timer
This command sets the period of time between sending new ISDP packets. The range is given in seconds.
Default
30 seconds
Format
isdp timer <5-254>
Mode
Global Config
isdp advertise-v2
This command enables the sending of ISDP version 2 packets from the device.
Default
Enabled
Format
isdp advertise-v2
Mode
Global Config
no isdp advertise-v2
This command disables the sending of ISDP version 2 packets from the device.
Format
no isdp advertise-v2
Mode
Global Config
isdp enable
This command enables ISDP on the interface.
Note: ISDP must be enabled both globally and on the interface in order for the interface to transmit ISDP packets.
If ISDP is globally disabled on the switch, the interface will not transmit ISDP packets, regardless of the ISDP
status on the interface. To enable ISDP globally, use the command
Default
Enabled
Format
isdp enable
Mode
Interface Config
"isdp run" on page
156.
ISDP Commands
157
Advertisement
Table of Contents
