D-Link DWS-4000 Series Cli Command Reference page 81

no storm-control broadcast all rate
This command sets the broadcast storm recovery threshold to the default value for all interfaces and disables broadcast
storm recovery.
Format
no storm-control broadcast all rate
Mode Global Config
storm-control multicast
This command enables multicast storm recovery mode for an interface. If the mode is enabled, multicast storm recovery is
active, and if the rate of L2 multicast traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of multicast traffic will be limited to the configured threshold.
Default disabled
Format
storm-control multicast
Mode Interface Config
no storm-control multicast
This command disables multicast storm recovery mode for an interface.
Format
no storm-control multicast
Mode Interface Config
storm-control multicast level
This command configures the multicast storm recovery threshold for an interface as a percentage of link speed and enables
multicast storm recovery mode. If the mode is enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic
ingressing on an interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of
multicast traffic will be limited to the configured threshold.
Default 5
Format
storm-control multicast level <0-100>
Mode Interface Config
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for an interface and disables multicast storm
recovery.
Format
no storm-control multicast level <0-100>
Mode Interface Config
Storm-Control Commands
73