Ip Routing Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
Term Definition
Dynamic Renew Displays whether the ARP component automatically attempts to renew dynamic ARP entries when
Mode they age out.
Total Entry Count The total entries in the ARP table and the peak entry count in the ARP table.
Current / Peak
Static Entry Count The static entry count in the ARP table and maximum static entry count in the ARP table.
Current / Max
show arp switch
This command displays the contents of the switch's Address Resolution Protocol (ARP) table.
Format
show arp switch
Mode Privileged EXEC
Term Definition
IP Address The IP address of a device on a subnet attached to the switch.
MAC Address The hardware MAC address of that device.
Interface The routing slot/port associated with the device's ARP entry.
IP R C
OUTING OMMANDS
This section describes the commands you use to enable and configure IP routing on the switch.
routing
This command enables routing for an interface. You can view the current value for this function with the show ip brief
command. The value is labeled as "Routing Mode."
Default disabled
Format
routing
Mode Interface Config
no routing
This command disables routing for an interface.
You can view the current value for this function with the show ip brief command. The value is labeled as "Routing Mode."
Format
no routing
Mode Interface Config
© 2009 D-Link Corporation. All Rights Reserved
168