D-Link DWS-4000 Series Cli Command Reference page 64

D-Link Unified Switch CLI Command Reference
dot1x guest-vlan
This command configures VLAN as guest vlan on a per port basis. The command specifies an active VLAN as an IEEE
802.1x guest VLAN. The range is 1 to the maximumVLAN ID supported by the platform.
Default disabled
Format
dot1x guest-vlan <vlan-id>
Mode Interface Config
no dot1x guest-vlan
This command disables Guest VLAN on the interface.
Default disabled
Format
no dot1x guest-vlan
Mode Interface Config
dot1x initialize
This command begins the initialization sequence on the specified port. This command is only valid if the control mode for
the specified port is auto or mac-based. If the control mode is not auto or mac-based, an error will be returned.
Format
dot1x initialize <slot/port>
Mode Privileged EXEC
dot1x login
This command assigns the specified authentication login list to the specified user for 802.1x port security. The <user>
parameter must be a configured user and the <listname> parameter must be a configured authentication login list.
Format
dot1x login <user> <listname>
Mode Global Config
dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will transmit an EAPOL EAP
Request/Identity frame before timing out the supplicant. The <count> value must be in the range 1 - 10.
Default 2
Format
dot1x max-req <count>
Mode Interface Config
no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will transmit an EAPOL EAP
Request/Identity frame before timing out the supplicant.
© 2009 D-Link Corporation. All Rights Reserved
56