D-Link DWS-4000 Series Cli Command Reference page 83

no storm-control multicast all level
This command sets the multicast storm recovery threshold to the default value for all interfaces and disables multicast storm
recovery.
Format
no storm-control multicast all level
Mode Global Config
storm-control multicast all rate
Use this command to configure the multicast storm recovery threshold for all interfaces in packets per second. If the mode
is enabled, multicast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases
beyond the configured threshold, the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured
threshold.
Default 0
Format
storm-control multicast rate <0-33554431>
Mode Global Config
no storm-control broadcast all rate
This command sets the broadcast storm recovery threshold to the default value for all interfaces and disables broadcast
storm recovery.
Format
no storm-control broadcast all rate
Mode Global Config
storm-control unicast
This command enables unicast storm recovery mode for an interface. If the mode is enabled, unicast storm recovery is
active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on an interface increases beyond
the configured threshold, the traffic will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the
configured threshold.
Default disabled
Format
storm-control unicast
Mode Interface Config
no storm-control unicast
This command disables unicast storm recovery mode for an interface.
Format
no storm-control unicast
Mode Interface Config
Storm-Control Commands
75