D-Link DWS-4000 Series Cli Command Reference page 454

D-Link Unified Switch CLI Command Reference
netbios-name-server
This command configures NetBIOS Windows Internet Naming Service (WINS) name servers that are available to DHCP
clients.
One IP address is required, although one can specify up to eight addresses in one command line. Servers are listed in order
of preference (address1 is the most preferred server, address2 is the next most preferred server, and so on).
Default none
Format
netbios-name-server <address> [<address2>...<address8>]
Mode DHCP Pool Config
no netbios-name-server
This command removes the NetBIOS name server list.
Format
no netbios-name-server
Mode DHCP Pool Config
netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host Configuration Protocol (DHCP) clients. Valid
types are:
• b-node—Broadcast
• p-node—Peer-to-peer
• m-node—Mixed
• h-node—Hybrid (recommended)
Default none
Format
netbios-node-type <type>
Mode DHCP Pool Config
no netbios-node-type
This command removes the NetBIOS node Type.
Format
no netbios-node-type
Mode DHCP Pool Config
next-server
This command configures the next server in the boot process of a DHCP client.The <address> parameter is the IP address
of the next server in the boot process, which is typically a TFTP server.
Default inbound interface helper addresses
Format
next-server <address>
Mode DHCP Pool Config
© 2009 D-Link Corporation. All Rights Reserved
446