D-Link DWS-4000 Series Cli Command Reference page 58

D-Link Unified Switch CLI Command Reference
Default 60
Format
set garp timer leave <20-600>
Mode • Interface Config
• Global Config
no set garp timer leave
This command sets the GVRP leave time on all ports or a single port to the default and only has an effect when GVRP is
enabled.
Format
no set garp timer leave
Mode • Interface Config
• Global Config
set garp timer leaveall
This command sets how frequently Leave All PDUs are generated. A Leave All PDU indicates that all registrations will be
unregistered. Participants would need to rejoin in order to maintain registration. The value applies per port and per GARP
participation. The time may range from 200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds. You can
use this command on all ports (Global Config mode) or a single port (Interface Config mode), and it only has an effect only
when GVRP is enabled.
Default 1000
Format
set garp timer leaveall <200-6000>
Mode • Interface Config
• Global Config
no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated the default and only has an effect when GVRP is enabled.
Format
no set garp timer leaveall
Mode • Interface Config
• Global Config
show garp
This command displays GARP information.
Format
show garp
Mode • Privileged EXEC
• User EXEC
Term Definition
GMRP Admin Mode The administrative mode of GARP Multicast Registration Protocol (GMRP) for the system.
GVRP Admin Mode The administrative mode of GARP VLAN Registration Protocol (GVRP) for the system.
© 2009 D-Link Corporation. All Rights Reserved
50