Captive Portal Local User Commands - D-Link DWS-4000 Series Cli Command Reference

C P
APTIVE ORTAL
Use these commands to view and configure captive portal users in the local database.
user (Captive Portal Config Mode)
This command is used to create a local user. The <user-id> variable is the user ID, which can be a number between 1
and 128. The password is 8-64 characters. You can modify the password after you create the user by using this command
with the user ID and a new password.
There are two ways to create the user: using name and using password. If the user is created using name, the password
needs to be assigned with the user password command. Or, if the user is created using password, the name can be assigned
later:
Format
user <user-id> name <password>
Mode Captive Portal Config
Format
user <user-id> password <password>
Mode Captive Portal Config
Example: The following shows an example using name to create the user.
(DWS-4026)(Config-CP) #user 1 name test
Example: The following shows an example using password to create the user.
(DWS-4026)(Config-CP) #user 1 password test1234<cr>
no user
This command deletes a user from the local user database. If the user has an existing session, it is disconnected.
Format
no user <user-id>
Mode Captive Portal Config
Example: The following shows an example of the command.
(DWS-4026)(Config-CP) #no user 1<cr>
user name
This command assigns a name to the User ID. This name is used at the client station for authentication. The <user-id>
variable is the local user ID created with the user command and can be from 1 to 128 characters. The <username> variable
is the name of the user and can have up to 32 alphanumeric characters.
Format
user <user-id> name <username>
Mode Captive Portal Config
L U C
OCAL SER

Captive Portal Local User Commands

OMMANDS
367