D-Link DWS-4000 Series Cli Command Reference page 79

no storm-control broadcast
Use this command to disable broadcast storm recovery mode for a specific interface.
Format
no storm-control broadcast
Mode Global Config
Interface Config
storm-control broadcast level
Use this command to configure the broadcast storm recovery threshold for an interface as a percentage of link speed and
enable broadcast storm recovery. If the mode is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast
traffic ingressing on an interface increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of
broadcast traffic is limited to the configured threshold.
Default 5
Format
storm-control broadcast level <0-100>
Mode Interface Config
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for an interface and disables broadcast storm
recovery.
Format
no storm-control broadcast level
Mode Interface Config
storm-control broadcast rate
Use this command to configure the broadcast storm recovery threshold for an interface in packets per second. If the mode
is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases
beyond the configured threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is limited to the configured
threshold.
Default 0
Format
storm-control broadcast rate <0-33554431>
Mode Interface Config
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for an interface and disables broadcast storm
recovery.
Format
no storm-control broadcast rate
Mode Interface Config
Storm-Control Commands
71