D-Link DWS-4000 Series Cli Command Reference page 282

D-Link Unified Switch CLI Command Reference
Format
no rate {basic | supported} <value>
Mode AP Profile Radio Config
Parameter Description
value A valid rate based on radio mode.
wmm
This command enables WMM mode for the radio. WMM mode is Wi-Fi Multimedia mode. When enabled QoS settings affect
both downstream traffic to the station (AP EDCA parameters) and upstream traffic to the AP (station EDCA parameters).
When disabled, QoS only applies to downstream traffic.
Default Enabled
Format
wmm
Mode AP Profile Radio Config
no wmm
The no version of this command disables WMM mode for the radio.
Format
no wmm
Mode AP Profile Radio Config
load-balance
This command enables load balancing. The optional utilization parameter indicates the percentage of network utilization
allowed on the radio before clients are denied. 0% indicates that no load balancing is performed.
Default • Disabled
• utilization, 60%
Format
load-balance [utilization <1-100>]
Mode AP Profile Radio Config
Parameter Description
1-100 Percentage of network utilization allowed on the radio.
no load-balance
The no version of this command disables load balancing or resets the utilization to its default value. If no parameters are
entered, load balancing is disabled.
Format
no load-balance [utilization]
Mode AP Profile Radio Config
© 2009 D-Link Corporation. All Rights Reserved
274