D-Link Unified Switch CLI Command Reference
Note: This command is only applicable to physical interfaces.
no lacp actor port priority
Use this command to configure the default priority value assigned to the Aggregation Port.
Format
no lacp actor port priority
Mode
Interface Config
lacp actor system priority
Use this command to configure the priority value associated with the LACP Actor's SystemID. The range for <priority>
is 0 to 255.
Default
0x80
Format
lacp actor system priority <priority>
Mode
Interface Config
Note: This command is only applicable to physical interfaces.
no lacp actor system priority
Use this command to configure the priority value associated with the Actor's SystemID.
Format
lacp actor system priority
Mode
Interface Config
lacp partner admin key
Use this command to configure the administrative value of the Key for the protocol partner. The valid range for <key> is 0
to 65535.
Default
0x0
Format
lacp partner admin key <key>
Mode
Interface Config
Note: This command is only applicable to physical interfaces.
no lacp partner admin key
Use this command to configure the administrative value of the Key for the protocol partner.
Format
no lacp partner admin key <key>
Mode
Interface Config
© 2009 D-Link Corporation. All Rights Reserved
84