Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
Key Sequence
Exit
?
U
CLI H
SING
ELP
Enter a question mark (?) at the command prompt to display the commands available in the current mode.
(DWS-4026) >?
enable
help
logout
ping
quit
show
telnet
Enter a question mark (?) after each word you enter to display available command keywords or parameters.
(DWS-4026) #network ?
javamode
mgmt_vlan
parms
protocol
If the help output shows a parameter in angle brackets, you must replace the parameter with a value.
(DWS-4026) #network parms ?
<ipaddr>
If there are no additional command keywords or parameters, or if additional parameters are optional, the following message
appears in the output:
<cr>
You can also enter a question mark (?) after typing one or more characters of a word to list the available command or
parameters that begin with the letters, as shown in the following example:
(DWS-4026) #show m?
mac-addr-table
© 2009 D-Link Corporation. All Rights Reserved
10
Table 8: CLI Editing Conventions (Cont.)
Description
Go to next lower command prompt.
List available commands, keywords, or parameters.
Enter into user privilege mode.
Display help for various special keys.
Exit this session. Any unsaved changes are lost.
Send ICMP echo packets to a specified IP address.
Exit this session. Any unsaved changes are lost.
Display Switch Options and Settings.
Telnet to a remote host.
Enable/Disable.
Configure the Management VLAN ID of the switch.
Configure Network Parameters of the router.
Select DHCP, BootP, or None as the network config
protocol.
Enter the IP address.
Press Enter to execute the command
mac-address-table
monitor
Advertisement
Table of Contents
