Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
authenticator PAE unconditionally sets the controlled port to authorized. Select auto to specify that the authenticator PAE
sets the controlled port mode to reflect the outcome of the authentication exchanges between the supplicant, authenticator
and the authentication server. If the
the port.
Note: MAC-based dot1x authentication is supported on the BCM56224, BCM56514, BCM56624, and BCM56820
platforms.
Default
auto
Format
dot1x port-control all {force-unauthorized | force-authorized | auto | mac-
based}
Mode
Global Config
no dot1x port-control all
This command sets the authentication mode on all ports to the default value.
Format
no dot1x port-control all
Mode
Global Config
dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is only valid if the control mode
for the specified port is auto or mac-based. If the control mode is not auto or mac-based, an error will be returned.
Note: MAC-based dot1x authentication is supported on the BCM56224, BCM56514, BCM56624, and BCM56820
platforms.
Format
dot1x re-authenticate <slot/port>
Mode
Privileged EXEC
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
Default
disabled
Format
dot1x re-authentication
Mode
Interface Config
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format
no dot1x re-authentication
Mode
Interface Config
© 2009 D-Link Corporation. All Rights Reserved
58
mac-based
option is specified, then MAC-based dot1x authentication is enabled on
Advertisement
Table of Contents
