Gvrp Commands - D-Link DWS-4000 Series Cli Command Reference

GVRP C
OMMANDS
This section describes the commands you use to configure and view GARP VLAN Registration Protocol (GVRP) information.
GVRP-enabled switches exchange VLAN configuration information, which allows GVRP to provide dynamic VLAN creation
on trunk ports and automatic VLAN pruning.
Note: If GVRP is disabled, the system does not forward GVRP messages.
set gvrp adminmode
This command enables GVRP on the system.
Default disabled
Format
set gvrp adminmode
Mode Privileged EXEC
no set gvrp adminmode
This command disables GVRP.
Format
no set gvrp adminmode
Mode Privileged EXEC
set gvrp interfacemode
This command enables GVRP on a single port (Interface Config mode) or all ports (Global Config mode).
Default disabled
Format
set gvrp interfacemode
Mode • Interface Config
• Global Config
no set gvrp interfacemode
This command disables GVRP on a single port (Interface Config mode) or all ports (Global Config mode). If GVRP is
disabled, Join Time, Leave Time and Leave All Time have no effect.
Format
no set gvrp interfacemode
Mode • Interface Config
• Global Config
show gvrp configuration
This command displays Generic Attributes Registration Protocol (GARP) information for one or all interfaces.

GVRP Commands

51