D-Link DWS-4000 Series Cli Command Reference page 82

D-Link Unified Switch CLI Command Reference
storm-control multicast rate
Use this command to configure the multicast storm recovery threshold for an interface in packets per second. If the mode is
enabled, multicast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases beyond
the configured threshold, the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured threshold.
Default 0
Format
storm-control multicast rate <0-33554431>
Mode Interface Config
no storm-control multicast rate
This command sets the multicast storm recovery threshold to the default value for an interface and disables multicast storm
recovery.
Format
no storm-control multicast rate
Mode Interface Config
storm-control multicast all
This command enables multicast storm recovery mode for all interfaces. If the mode is enabled, multicast storm recovery is
active, and if the rate of L2 multicast traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of multicast traffic will be limited to the configured threshold.
Default disabled
Format
storm-control multicast all
Mode Global Config
no storm-control multicast all
This command disables multicast storm recovery mode for all interfaces.
Format
no storm-control multicast all
Mode Global Config
storm-control multicast all level
This command configures the multicast storm recovery threshold for all interfaces as a percentage of link speed and enables
multicast storm recovery mode. If the mode is enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic
ingressing on an interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of
multicast traffic will be limited to the configured threshold.
Default 5
Format
storm-control multicast all level <0-100>
Mode Global Config
© 2009 D-Link Corporation. All Rights Reserved
74