Hypertext Transfer Protocol Commands - D-Link DWS-4000 Series Cli Command Reference

H T
YPERTEXT RANSFER
This section describes the commands you use to configure Hypertext Transfer Protocol (HTTP) and secure HTTP access
to the switch. Access to the switch by using a Web browser is enabled by default. Everything you can view and configure by
using the CLI is also available by using the Web.
ip http server
This command enables access to the switch through the Web interface. When access is enabled, the user can login to the
switch from the Web interface. When access is disabled, the user cannot login to the switch's Web server. Disabling the Web
interface takes effect immediately. All interfaces are affected.
Default enabled
Format
ip http server
Mode Privileged EXEC
no ip http server
This command disables access to the switch through the Web interface. When access is disabled, the user cannot login to
the switch's Web server.
Format
no ip http server
Mode Privileged EXEC
ip http secure-server
This command is used to enable the secure socket layer for secure HTTP.
Default disabled
Format
ip http secure-server
Mode Privileged EXEC
no ip http secure-server
This command is used to disable the secure socket layer for secure HTTP.
Format
no ip http secure-server
Mode Privileged EXEC
ip http java
This command enables the Web Java mode. The Java mode applies to both secure and un-secure Web connections.
Default Enabled
Format
ip http java
Mode Privileged EXEC
P C
ROTOCOL OMMANDS

Hypertext Transfer Protocol Commands

485