Table of Contents
Advertisement
Parameter
Description
Automatic Channel
Indicates if automatic channel adjustment is enabled. If enabled, the initial AP channel assignment can
Adjustment
be automatically adjusted by the switch due to changes in the network.
Automatic Power
Indicates if automatic power adjustment is enabled. If enabled, the switch may modify the power on
Adjustment
the radio due to changes in performance.
Initial Power (%)
Indicates a default power setting for the radio. If automatic power adjustment is disabled, this indicates
a fixed power setting, otherwise it indicates the initial power setting before any automatic adjustments.
Load Balancing
Indicates if the AP will load balance users on this radio.
Load Utilization
If load balancing is enabled, % of network utilization allowed on the radio before clients are denied.
Station Isolation
Indicates whether or not Station Isolation is enabled on the radio. When enabled the AP does not allow
data traffic among wireless clients.
Channel
Indicates the bandwidth used in the channel when the radio is operating in 802.11n mode.
Bandwidth
Primary Channel
Specifies the relative location of the primary channel in the 40MHz channel when the radio is operating
in 802.11n mode.
Protection
Indicates if the 802.11n protection mechanism is turned on or off, or if it is in the Auto mode.
Short Guard
Indicates the short guard interval configured on the radio when it is operating in 802.11n mode.
Interval
Multicast Transmit
Indicates the 802.11 rate at which the radio transmits multicast frames.
Rate
Automatic Power
Indicates if power save delivery mode is enabled or disabled on the radio.
Save Delivery
Mode
No Ack
Indicates if acknowledgement has to be sent for incorrectly received frames.
Example: The following shows example CLI display output for the command.
(DWS-4026) # show wireless ap profile 1 radio 1
AP Profile ID.................................. 1
Profile Name................................... Default
Radio.......................................... 1 - 802.11a/n
Status......................................... On
Mode........................................... 802.11a/n
RF Scan - Other Channels Mode.................. Enable
RF Scan - Other Channels Scan Interval......... 60
RF Scan - Sentry Mode.......................... Disable
RF Scan - Sentry Scan Channels................. All
RF Scan - Scan Duration........................ 10
Enable Broadcast/Multicast Rate Limiting....... Disable
Broadcast/Multicast Rate Limit................. 50
Broadcast/Multicast Rate Limit Burst........... 75
Beacon Interval................................ 100
DTIM Period.................................... 10
Fragmentation Threshold........................ 2346
RTS Threshold (bytes).......................... 2347
Short Retry Limit.............................. 7
Long Retry Limit............................... 4
Maximum Transmit Lifetime...................... 512
Maximum Receive Lifetime....................... 512
Maximum Clients................................ 200
--More-- or (q)uit
Access Point Profile RF Commands
279
Advertisement
Table of Contents
